Birds of Prey Aviaries
Our aviaries are made using 50mm by 38mm pressure treated Grade A timbers. The normal wire I use for these aviaries is 1" x 1" 16 gauge welded mesh. The mesh is held onto the timber frame by using 20mm staples which are put into the frame under compressed air. The door of the aviary is hung using three gate hinges and the door is secured by a barrel bolt. For the roof we use mineral felt and the sides of the aviary are made using solid shiplap timbers to keep your bird warm and out of the wind.
Different designs and sizes to the ones shown are available. We build entirely to order, so please just tell us the dimensions you require using our Online Quote form.
This aviary is 12 ft long x 6 ft wide x 6 ft 9 inches with an apex roof.
The aviary has a solid ship lap shelter which is segregated in half to allow you to enter and feed your birds
with out them escaping. The inner housing has a entrance door and two internal ports to allow the birds to fly
out into the flight and also a floor base port to enable you to sweep out the bottom.
The aviary is built using 50 mm 38 mm pressure treated timbers and 16 gauge 1" x 1" welded mesh, the roof is solid and mineral felted
This aviary has a 2/3 mineral felt roof.
